Coming to the finishing stages of the "Sock-Stealer" model, I went over some areas that needed improving in the wrists/ankles and have now created the jacket.
To make the jacket, I duplicated the body model as a base mesh than made alterations to get the shape I wanted. Around the tail, I wanted the cloth to brunch up a little like it was just resting on the tail base. For making the trimmings, I copied the jacket twice again, removed everything but the top/bottom most lines of geometry and then extruded inwards. With this, I was able to create the trimmings without having to worrying too much about them being it the right place.
Currently there is no detailing to the trimmings but I hoping that bump/normal maps will help here. The last bit to do will be to place some threading on the jacket buttons and doing one last clean up to make sure everything is correct (while ensuring the geometry is clean).
Next, I will either do the "Pipe-Tappers" modelling or start the rigging process.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.